Posted on: June 28th, 2016 by

Your tire pressure sensor will have to be reset when you install new tires and wheels onto your vehicle.   New tires are a very important safety factor for your vehicle.  Your tires can get old and dry rot, or in some a belt could break leaving them at a risk of blowing out.  Some tires have cords inside of them that will poke through the tread leaving a huge safety hazard to your driving safety.  If your car does not have a proper alignment, this could cause your vehicle’s tires to wear unevenly, putting it at risk for a blow out.  All of these things can effect  your ability  to control your vehicle.  Good tires with good tread and proper air pressure are all part of a vital safety factor for you and your family when traveling in your vehicle.

When To Add New Tires

Many garages will gauge the tread on your tires and have a rating system as to when the tread is too worn and new tires need to be put on your vehicle.  As the tread wears off of your tires, your traction between your vehicle and the roadways will lessen. You can also checkout our top article here. It is important to have your tires checked for defects or to see if they are just plain worn out by a professional mechanic or tire shop.  It is important to know what type and size of tires that are required for your vehicle.  Some vehicles may have different size tires on the front and the rear of your vehicle.  Making sure new tires and wheels are installed correctly is a vital factor.  Many people will use an experienced professional to do this for them.

How To Install Your Tire & Wheel Package

Proper Steps To Add New Wheels And Tires

  • Loosen the lug nuts on your wheels
  • Raise your vehicle high enough to give your tires clearance and block with a jack stand
  • Finish taking off the lug nuts and then remove the wheels
  • Check your lug studs and make sure they are tight and sturdy
  • Make sure your new wheels are a proper fit and alignment with the studs

Your Instillation

Make sure your tpms sensors will allign with your new set up.  Once you know your wheels are going to be a proper fit, make sure that you tires will properly fit the wheels.  Once your tires are on your wheels, put them back onto your studs and tighten them down with a lug wrench.  Put your vehicle into neutral and turn your wheels by hand to make sure there is not resistance and your new wheels will clear all components.  After driving your vehicle approximately 75 miles recheck your lug nuts and make sure that they are still secure.

Make sure that you have made the proper tire selection for your vehicle.  Your tire professional can help you select the proper fit and type.  If you need to know more you can visit this linkhttp://www.mobilemastertrucks.com/how-does-my-car-monitor-tire-pressure/ here. There are many tread types and styles to choose from.  There are also directional tires, asymmetric tires and a combination of both types.  Make sure that these are installed per manufacturers direction.  Be sure to check your tire system and reset if needed even if you are using an aftermarket tpms system.

Leave a Reply

Your email address will not be published. Required fields are marked *